Resistors type ‘WW’ are manufactured with Stainless Steel Wire (AISI 304) having temperature co-efficient of 0.094% per*C wound on Steel Plate with Porcelain Channels at the edges. These Resistors are widely used for Higher Resistances Values, but Low Current.

• HP/KW of motor
• Rotor Voltage (RV)
• Rotor Current (RA)
• Rating (5mm / 10mm / continuous)
• Total resistance / phase
• No. of steps resistances
• Resistance values at each step
• IP – Protection required (STD IP-23)
• Temp. rise required (STD 375º C)
• Draw-out type consumption required / not required
• Electrical clearance (25mm standard)

Resistors type 'PSS' are manufactured with grids punched out from Stainless Steel Plate (AISI 304). Each Resistor Grid has provision for termination which helps in changing the step Resistance Values of a given Resistor Assembly with out dismantling the whole assembly. These grids retain the end of the Grids and still remain cool which eliminates the hot spots from developing.

• HP/KW of motor
• Rotor Voltage (RV)
• Rotor Current (RA)
• Rating (5mm / 10mm / continuous)
• Total resistance / phase
• No. of steps resistances
• Resistance values at each step
• IP – Protection required (STD IP-23)
• Temp. rise required (STD 375º C)
• Draw-out type consumption required / not required
• Electrical clearance (25mm standard)

Resistors type ‘FS’ are manufactured with grids punched out of Plates of Steel – Chromium-Aluminium Alloy (widely known as ‘Fe Cr Al’ –AISI 406).

• HP/KW of motor
• Rotor Voltage (RV)
• Rotor Current (RA)
• Rating (5mm / 10mm / continuous)
• Total resistance / phase
• No. of steps resistances
• Resistance values at each step
• IP – Protection required (STD IP-23)
• Temp. rise required (STD 375º C)
• Draw-out type consumption required / not required
• Electrical clearance (25mm standard)

An Earthing Resistor is primarily a safety device. It drastically reduces shock hazards to personnel and equipment. We have, therefore, developed Earthing Resistors for your benefit. Grids are manufactured from a special alloy of stainless steel which makes them rustless and unbreakable thus eliminating maintenance problem and suitable for installation in outdoor atmosphere.

• HP/KW of motor
• Rotor Voltage (RV)
• Rotor Current (RA)
• Rating (5mm / 10mm / continuous)
• Total resistance / phase
• No. of steps resistances
• Resistance values at each step
• IP – Protection required (STD IP-23)
• Temp. rise required (STD 375º C)
• Draw-out type consumption required / not required
• Electrical clearance (25mm standard)