ELEKTROMAG Moulded Plastic Cable Drag Chains are a logical addition to the range of the steel Cable Drag Chains which have proved themselves worldwide for over 25 years.

They can be used wherever the required energy input cables/hoses are light, the travel is small and the environmental conditions permit the use of plastics.

The chain links and separating plates for taking the cables/hoses, from a single unit in the ELEKTROMAG Cable Drag Chains. The  individual  chain  links can  be connected  by a snap  connection  enabling  them to be joined  to form  a chain of any  required length. One of the advantages of this system is that the customer can make up any required length of chain so that stocks can be kept and it is not necessary to place an order for each requirement.   

CHAIN TYPE  :  0320 ,  0320/1 ,  0450/1 ,  0450/11 ,  0625 ,  0700 (*) ,  0900 (*)

If the permissible unsupported length of the chain is exceeded, due to its elastic characteristics the upper section of the chain rests on the lower one. Due to the excellent anti-friction characteristics of the plastic material used, this does not impair the function of the chain when moving.

Chain Type 0700 (*) and 0900 (*) can be supplied with Alum. Stays for variable width

* Can also be supplied with variable plastic flaps (open) for widths 200,250, & 300 mm only .

To specify a ELEKTROMAG Moulded Plastic Cable Drag Chain, we require the following information:

• Lenth of travel
• Number and outside diameter of the cables/hoses to be installed
• Required minimum bending radius of cables or hoses
• Types of application (drwg. If possible)